Gree GFH09K3FI - Page 64


U-Match Series DC
Inverter Service Manual
,QVWDOOLQJWKH0DLQ%RG\8QLW
)LJXUH
(1). nstall the hoisting stand on the hoisting screw by using nuts and gaskets at both the upper and lower
sides of the hoisting stand. To prevent the gasket from breaking off, a gasket anchor board can be helpful.
(2). ,QVWDOOWKHSDSHUWHPSODWHRQWKHXQLWDQG¿[WKHGUDLQSLSHDWWKHRXWOHWYHQW
(3). Adjust the unit to the best position.
(4). &KHFNLIWKHXQLWLVLQVWDOOHGKRUL]RQWDOO\DWIRXUGLUHFWLRQV,IQRWWKHZDWHUSXPSDQGWKHÀRDWVZLWFK
would function improperly and even lead to water leakage.
5HPRYHWKHJDVNHWDQFKRUERDUGDQGWLJKWHQWKHQXWUHPDLQHG
5HPRYHWKHSDSHUWHPSODWH
1.3.4 Installing the Suspension Bolts
(1). 8VLQJWKHLQVWDOODWLRQWHPSODWHGULOOKROHVIRUEROWVIRXUKROHV)LJXUH
(2). Install the bolts to the ceiling at a place strong enough to hang the unit. Mark the bolt positions from the
LQVWDOODWLRQWHPSODWH:LWKDFRQFUHWHGULOOGULOOIRUPP´GLDPHWHUKROHV)LJXUH
(3). Insert the anchor bolts into the drilled holes, and drive the pins completely into the anchor bolts with a
KDPPHU)LJXUH
)LJXUH)LJXUH)LJXUH
/HYHOLQJ
The water level test must be done after installing the indoor unit to make the unit is horizontal, as shown
below.
Horizontal tester
)LJXUH