U-Match Series DC
Inverter Service Manual
3.1.2 Bending Pipes
(1). The pipes are shaped by your hands. Be careful not to collapse them.
)LJXUH
(2). 'RQRWEHQGWKHSLSHVLQDQDQJOHPRUHWKDQ
(3). :KHQSLSHVDUHUHSHDWHGO\EHQWRUVWUHWFKHGWKHPDWHULDOZLOO
KDUGHQPDNLQJLWGLI¿FXOWWREHQGRUVWUHWFKWKHPDQ\PRUHQRWEHQG
or stretch the pipes more than three times.
(4). :KHQEHQGLQJWKHSLSHGRQRWEHQGLWDVLV7KHSLSHZLOOEH
collapsed. In this case, cut the heat insulating pipe with a sharp cutter
DVVKRZQLQ)LJXUHDQGEHQGLWDIWHUH[SRVLQJWKHSLSH$IWHU
bending the pipe as you want, be sure to put the heat insulating pipe
back on the pipe, and secure it with tape.
Pipe
Cutter
Cutt line
Heat insulating
pipe
)LJXUH
CAUTION!
ķ
7RSUHYHQWEUHDNLQJRIWKHSLSHDYRLGVKDUSEHQGV%HQGWKHSLSHZLWKDUDGLXVRIFXUYDWXUHRIPPRU
over.
ĸ
If the pipe is bent repeatedly at the same place, it will break.
&RQQHFWLQJWKH3LSHDWWKH,QGRRU8QLW6LGH
Detach the caps and plugs from the pipes.
CAUTION!
ķ
%HVXUHWRDSSO\WKHSLSHDJDLQVWWKHSRUWRQWKHLQGRRUXQLWFRUUHFWO\,IWKHFHQWHULQJLVLPSURSHUWKHÀDUH
QXWFDQQRWEHWLJKWHQHGVPRRWKO\,IWKHÀDUHQXWLVIRUFHGWRWXUQWKHWKUHDGVZLOOEHGDPDJHG
ĸ
Do not remove the flare nut until the connection pipe is to be connected so as to prevent dust and
impurities from coming into the pipe system.
:KHQFRQQHFWLQJWKHSLSHWRWKHXQLWRUUHPRYLQJLWIURPWKHXQLWSOHDVHGRXVHERWKWKHVSDQQHUDQGWKH
WRUTXHZUHQFK)LJXUH
:KHQFRQQHFWLQJVPHDUERWKLQVLGHDQGRXWVLGHRIWKHÀDUHQXWZLWKUHIULJHUDWLRQRLOVFUHZLWKDQGWLJKW
and then tighten it with the spanner.
5HIHUWR7DEOHWRFKHFNLIWKHZUHQFKKDVEHHQWLJKWHQHGSURSHUO\WRRWLJKWZRXOGPDQJOHWKHQXWDQG
lead to leakage).
Examine the connection pipe to see if it leaks, then take the treatment of heat insulation, as shown in the
)LJXUH
8VHWKHPHGLXPVL]HGVSRQJHWRLQVXODWHWKHFRXSOHURIWKHJDVSLSH
To Next Page
Loading...
