DC Inverter Multi
VRF Service Manual
213
6. Mount xing
screw of gas-liquid
separator and electric
heating tape
● Move up the electric box and x it.
● Tighen the wire xer of
the right electric box.
7. Mount front panel
● Check if the parts and connecting
wires aire well connected.
● Fix the left and right front panels.
Removal and Assembly of Liquid Storage Tank
Remark: Before removing the liquid storage tank, make sure that there is no refrigerant inside the pipe system and that the power has been cut off.
Step Illustration Handling Instruction
1. Loosen the wire
xer of the left electric
box and the screws
● Remove the left and right front panels.
● Loosen the left and lower wire
xers of the left electric box.
● Loosen the screws xing
the left electric box.
2. Take off the left
electric box
● Put a support of suitable height
in front of the left electric box.
● Take off the electric box and lay
its front part on the support.
3. Disassemble the
liquid storage tank
Solder the spots
● Heat the 2 nozzles by gas welding
and remove the gas-liquid separator.
Note: do not burn the other
parts during soldering.
To Next Page
Loading...