GMV5 D.C INVERTER MULTI VRF SERVICE MANUAL
151
Outdoor:
PCB of wired controller is abnormal
Current sensor of compressor 2 is
abnormal
Discharge low-temperature protection
Current sensor of compressor 3 is
abnormal
Current sensor of compressor 4 is
abnormal
High discharge temperature protection of
compressor
Current sensor of compressor 5 is
abnormal
Current sensor of compressor 6 is
abnormal
Power supply is insufficient
For single control over multiple units,
number of IDU is inconsistent
Malfunction of casing top temperature
sensor of compressor 1
For single control over multiple units, IDU
series is inconsistent
Malfunction of casing top temperature
sensor of compressor 2
Alarm due to bad air quality
Malfunction of exit tube temperature
sensor of mode exchanger
Protection for other modules
Malfunction of inlet tube temperature
sensor of mode exchanger
Over-current protection of compressor 1
Malfunction of outdoor ambient
temperature sensor
Over-current protection of compressor 2
Malfunction of defrosting temperature
sensor 1
Over-current protection of compressor 3
Malfunction of defrosting temperature
sensor 2
Over-current protection of compressor 4
Malfunction of liquid temperature sensor
of sub-cooler
Over-current protection of compressor 5
Malfunction of gas temperature sensor
of sub-cooler
Over-current protection for compressor 6
Malfunction of inlet tube temperature
sensor of vapor liquid separator
Gas-mixing protection of 4-way valve
Malfunction of exit tube temperature
sensor of vapor liquid separator
High pressure ratio protection of system
Malfunction of outdoor humidity sensor
Low pressure ratio protection of system
Malfunction of gas temperature sensor
of heat exchanger
Protection because of abnormal
pressure
Malfunction of oil-return temperature
sensor 1
Water flow switch protection
Clock of system is abnormal
Protection because high pressure is too
low
Protection because the temperature
sensor at the top of compressor 1 is
loose
Oil-return pipe is blocked
Protection because the temperature
sensor at the top of compressor 2 is
loose