Gree GRS-CQ10Pd/NhG-M - Page 48

Unit Control
the setting page of this option.
★
4. At the weekday setting page, it is able to set the timer to ―
Valid
‖ or ―
Invalid
‖. Also, it is able to set
three timing periods, each of which can be set to ―
Valid
‖ or ―
Invalid
‖.
★
5. Then, by touching the ―
Save
‖ icon, this setting will be saved.
[Notes]
●Three periods can be set for each day. The start time should be earlier than the end time for each
period, otherwise this setting will be invalid. In the same way, the latter should be earlier than the
former.
●When the weekly timer has been activated, the display panel will act based on the current mode and
temperature setting.
●Timer setting for the weekday
―
Valid
‖ it indicates this setting works only when ―
Weekly timer
‖ has been activated, unaffected by
the holiday mode.
―
Invalid
‖ indicates this setting does not work even though the ―
Weekly timer”
has been activated.
●It will be memorized upon power failure.
3.2.2.8 Holiday Release
[Operation Instructions]
★
At the function setting page, by touching ―
Holiday release
‖, it will go to the corresponding setting page,
where it can be set to ―
On
‖ or ―
Off
‖.
[Notes]
●When this function has been activated, at the ‗
Weekly timer
‖ setting page, some week day can be set
to ―Holiday release‖. In this case, the setting of the ―Weekly timer‖ at this day is invalid unless it has been
manually set to ―
Valid
‖.
●It will be memorized upon power failure.
3.2.2.9 Disinfection
[Operation Instructions]
★
At the function setting page, access to ―
Disinfection
‖ setting page.
★
At the ―
Disinfection
‖ setting page, it can select the disinfection clock, disinfection temperature and
disinfection week and the corresponding setting page will pop up at the right side.
★
Then, this setting will be saved by touching the ―
Save
‖ icon.
[Notes]
●This setting can be activated only when ―
Water tank
‖ is set to ―
With
‖. When ―
Water tank
‖ is set to
―
Without
‖, this function will be deactivated.
●This setting can be done no matter if the unit is turned on or off.
● When ―
Emergen.mode
‖, ―
Holiday mode
‖, ―
Floor debug
‖, ―
Manual defrost
‖, or ―
Refri. recovery
‖