80
Installation and Maintenance
Service Manual
11. Removal Procedure
Step Procedure
12.Remove propeller housing, centrifugal blade and
motor
a
b
c
d
e
f
Remove 3 screws used for fixing the press plate of
propeller housing, and then take out the pressure plate
of propeller housing.
Rotate the diversion loop to a certain position in the
clockwise direction and then take out the diversion
loop.
Remove 9 screws used for xing the propeller housing
and then take out the propeller housing.
Use wrench to remove the nuts used for fixing the
centrifugal blade and then pull the centrifugal blade
outwards.
Take out the centrifugal blade.
Remove 4 screws xing the motor and 2 screws xing
the wire-pressing late, and then remove the motor.
13.Remove chassis
Remove 9 screws, pull it downwards and then remove
the chassis.
wire-pressing plate
diversion loop
centrifugal blade
motor
press plate of propeller
housing
propeller housing
chassis
To Next Page
Loading...
