79
Installation and Maintenance
Service Manual
11. Removal Procedure
Step Procedure
10.Remove top cover
Remove 5 screws used for xing the top cover, pull it
upwards and then remove the top cover.
11.Remove evaporator
Remove 4 screws used for fixing the top connection
board and lower connection board of evaporator and 2
screws used for xing the side plate, pull left and right
side plates outwards slightly and take out evaporator,
baffle board and water tray. After the evaporator is
removed, remove left and right wind boards on the
evaporator and the bafe board.
top cover
screw
evaporator
screw
screw
To Next Page
Loading...
