78
Installation and Maintenance
Service Manual
11. Removal Procedure
Step Procedure
7.Remove upper cover, horizontal louver, swing
board
a
b
c
Remove 2 screws at the upper part of the upper cover
and two screws at the back side of the air-outlet panel.
After removing the air-guiding connecting robe, and
then pull the horizontal louver outwards to remove it.
After removing the air swing connection rod, pull the
swing board inwards to remove it.
8.Remove swing motor and air-guide motor
a
b
Remove screws used for xing the airguide motor and
the remove the air-guide motor.
Remove screws used for xing the motor cover, remove
the motor cover and then remove the swing motor.
9.Remove wind board
Remove 11 screws used for xing the wind board and
then remove the wind board.
swing board
air swing
connecting rod
upper cover
horizontal louver
air-guiding connecting rod
screw
air-guide motor
motor cover
swing motor
screw
screw
wind board
To Next Page
Loading...
