AIR COOLED SCROLL CHILLER MAINTENANCE
38
Removal and Installation of Compressor
Remark: Before removing the compressor, make sure that there is no refrigerant inside the pipe system and that
the power has been cut off.
Step Illustration Handling Instruction
1.Remove the
power cord
z Use screwdriver to loosen the
screws fixing the power cable.
z Pull out the power cable.
z If compressor has e-heating
tape, it should also be removed.
Note: When removing the power
cable, please mark the power cable
color and corresponding terminal,
thus to avoid error during
reinstallation.
2. Remove the
nuts fixing the
compressor
z Screw off the screws fixing the
compressor with shifting
spanner or box spanner.
z The removed screws should be
put together in case of lost.
3.Disconnect
the pipe that
connects to
the
compressor
z During welding the pipe, take
care to finish it quickly in case
of superburning.
z Do not damage the compresser
in case analisis in the future.
To Next Page
Loading...
