Gree LSQWF65M/N-M - Removal and Inatllation of Condenser

AIR COOLED SCROLL CHILLER MAINTENANCE
43
Removal and Inatllation of Condenser
Remark: Cut off power the unit and reclaim refrigerant.
Step Illustration Handling Instruction
1.Remove the front
panel indicated by
the arrow (take
replacement of
condenser in the
front)
z Reclaim the refrigerant
completely
z Cut off power of the unit.
z Remove fan sub-assy and
cut off power cord of fan
motor and then remove
sheet metal wrapping the
condenser.
2. Remove metal
grill outside the
condenser.
z Remove grill of condenser.
3. Unsolder the
inlet/outlet tube
connecting
condenser. Pay
attention to flame
direction of welding
gun to avoid burnout
of condenser fin and
sheet metal sub-assy.
z Unsolder the connection
pipe of condenser
according to the left
illustration.
4. Remove the clamp
fixing the joint and
unsolder the two
pieces of small pipe
at the bottom of
condenser.
z Remove the support fixing
the joint with a spanner.
z Unsolder the samll
connection pipe of
condenser according to the
left illustration.
5. Install the new
condenser and
resume the fan and
sheet metal.
z Install the new condenser
according to the removal
procedure of it.
z Weld each connection pipe
with the welding gun.
z Re-connect the power cord
of fan motor. Pay attention
to sequence of connection
wire of fan motor.