A/A DC INVERTER U-MATCH AIR CONDITIONERS MAINTENANCE
162
4. Remove the front side
plate.
将前侧板从机组上移开
5. Disassemble the rear side
plate.
Loosen the screws on the rear
side plate with a screw driver.
6.Remove the rear side plate,
Remove the rear side plate
from the unit.
Removal and Installation of Gas-liquid Separator and Compressor
Remark: Before removing the compressor, make sure that there is no refrigerant inside the pipe
system and that the power has been cut off.
Step Illustration Handling Instruction
1. Disconnect the
wiring of the
power supply of
the compressor
a. Open the cover of the
power supply box with a
wrench.
b. Disconnect the power cord
of the compressor with the
pliers
c. Pull out the power supply
plug of the compressor
To Next Page
Loading...
