A/A DC INVERTER U-MATCH AIR CONDITIONERS INSTALLATION
82
Test hole cover
Drain hose
< Immiting water from the rest hole>
Above100mm
.
Drain vent for repair use (plastic
stopper is included) (drain the water
in waterspout by this outlet vent)
[Way of immiting]
Test hole
<Immiting water from the outlet
vent terminal>
Plastic water pot (The length of the
pipe should be about 100mm.)
Figure 1-3-12
1.3.7 Installation of panel
1） Set the panel to the indoor unit body by matching the position of the swing flap motor of the decoration panel to
the piping position of the panel to the piping position of the indoor unit as shown in Figure 1-3-13.
Figure 1-3-13
Hang the latch, which is located on the opposite side of the swing flap motor on the panel, temporarily to the
book of the indoor unit. (2 Positions)
Temporarily hang the remaining 2 latches to the hooks on the sides of the indoor unit.(Be careful not to let the
To Next Page
Loading...
