91
Installation and Maintenance
Service Manual
Step Procedure
6. Remove axial ow blade
Remove nut on blade with wrench,and then remove
the axial ow blade.
7. Remove electric box and reproof electric box
Remove screws xing electric box,cut off the tielien
with scissors, pull out the wiring terminal and then lift
up the electric box to remove it.
Twist off the screws on reproof electric box and then
remove the reproof electric box.
8. Remove motor and motor support
Twist off the tapping screws xingthe motor, pull
out the pin of leading wire for motor and then remove
the motor.
axial ow blade
electric box
motor
11. Removal Procedure
To Next Page
Loading...
