9.1 GENERAL INFORMATION
IMPORTANT
Only your dealer or approved service center can do
the maintenance that is not given in this manual.
Before the maintenance operations:
• Stop the machine.
• Remove the battery pack.
• Cool the motor.
• Store the machine in cool and dry place.
• Use correct clothing, protective gloves and safety
glasses.
9.2 CLEAN THE MACHINE
• Clean the machine after use with a moist cloth
dipped in neutral detergent.
• Do not use aggressive detergents or solvents to
clean the plastic parts or handles.
• Keep the trimmer head free of grass, leaves, or
excessive grease.
• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
• Do not spray water onto the motor and electrical
components.
9.3 INSTALL THE CUTTING LINE
NOTE
Do not put more than 15 feet of cutting line in at a
time.
1. Remove the remaining cutting line on the spool.
2. Line up the slots on the spool cap with the slots on
the trimmer head.
3. Put the cutting line through the hole. Push the
cutting line until it exits the opposite hole.
4. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
5. Turn the spool cap clock-wise to wind the cutting
line into the trimmer head. Keep approximately 5 in
of cutting line above out of each side of the trimmer
head.
(130
mm
)
=
(130
mm
)
5.1" 5.1"
=
9.4 REPLACE THE SPOOL
1. Push the tabs (19) on the sides of the trimmer head
at the same time.
8
English
EN
To Next Page
