GridConnect NET485 - Flush Mode (Buffer Flushing); Table 14 - Flush Mode Options

Device Installer
NET485 User Guide 3-21
3.7.12 Flush Mode (Buffer Flushing)
Using this parameter, you can control line handling and network buffers with connection startup and
disconnect. You can also select between two different packing algorithms.
Table 14 - Flush Mode Options
Function
7
6
5
4
3
2
1
0
Input Buffer (Serial to Network)
Clear with a connection that is initiated from
the device to the network
1
Clear with a connection initiated from the
network to the device
1
Clear when the network connection to or from
the device is disconnected
1
Output Buffer (Network to Serial)
Clear with a connection that is initiated from
the device to the network
1
Clear with a connection initiated from the
network to the device
1
Clear when the network connection to or from
the device is disconnected
1
Alternate Packing Algorithm (Pack Control)
Enable
1