-24-
Model G0440/G0441 (Mfg. Since 03/12)
18. Insert the rubber seal over the top lip of the
collection drum rim. Pay special attention
to the direction of the seal, as shown in the
Figure 28.
Tip: To keep the seal in place, you can use
an adhesive applied to the rubber seal at
approximately 1" intervals.
Figure 28. Installing canister seal.
Seal
Drum
Rim
Optional
Adhesive
19. Insert the larger of the plastic collection bags
into the collection drum, place the lid on the
collection drum and hook the latch over the
lid, as shown in Figure 29, then clamp it in
place.
Figure 29. Latch hooked over lid for clamping.
20. Move the collector drum under the dust col-
lector and connect it to the cyclone funnel
with the clear flexible hose and the two 9"
hose clamps, as shown in Figure 30.
Figure 30. Drum attached to cyclone funnel with
clear 9" hose.
21. Connect the vacuum hose to the cyclone fun-
nel and collection drum vacuum tubes with
(2) 1
1
⁄4" hose clamps (see Figure 31).
Figure 31. Connecting the vacuum hose.
To Next Page
Loading...
Need help?
General
