Grizzly G0462 User Manual (English)

Other manuals for Grizzly G0462

Questions and Answers:

A
Andrea ButlerJul 26, 2025
What to do if I can't remove a tapered tool from the quill of my Grizzly G0462?
- E
  Erin ReynoldsJul 26, 2025
  If you can't remove a tapered tool from the quill of your Grizzly Lathe, there are a couple of things to check. First, make sure the quill is fully retracted into the tailstock. Turn the quill handwheel until it forces the taper out. Also, ensure that you always clean the taper surfaces before inserting them into the quill to prevent debris from causing this issue.
F
fhallJul 30, 2025
Why am I getting inaccurate turning results on my Grizzly G0462?
- M
  millerrachelJul 30, 2025
  If you're getting inaccurate turning results from one end of the workpiece to the other on your Grizzly Lathe, it might be due to the headstock and tailstock not being properly aligned. Make sure to realign the tailstock to the headstock.
M
Maxwell HawkinsAug 4, 2025
What to do if the quill on my Grizzly G0462 will not move forward?
- K
  Kathryn JohnsonAug 4, 2025
  If the quill won't move forward into the workpiece when you turn the handwheel on your Grizzly Lathe, the keyway might not be aligned with the quill lock lever. Align the quill keyway with the quill lock lever and slightly tighten the lever to engage the keyway.
D
Dr. Brandon MillerAug 8, 2025
How to fix bad surface finish on Grizzly G0462 Lathe?
- J
  Jason MunozAug 8, 2025
  If you're experiencing a bad surface finish, it could be due to a few reasons. First, the spindle speed might be incorrect; experiment to find an optimal speed. Second, your chisel might be dull or the wrong type for the job; try sharpening it or switching to a different chisel.
M
Madison EstesAug 12, 2025
What to do if I can't remove tapered tool from quill of Grizzly Lathe?
- E
  Erika CrossAug 12, 2025
  If you are having trouble removing a tapered tool from the quill, there are a couple of things to check. First, make sure the quill is fully retracted into the tailstock by turning the quill handwheel. Second, ensure that the taper surfaces are always clean before inserting the tool into the quill, as debris can cause it to stick.
O
olsondanielAug 16, 2025
Why is Grizzly Lathe producing inaccurate turning results?
- T
  Troy YorkAug 16, 2025
  Inaccurate turning results from one end of the workpiece to the other can occur if the headstock and tailstock are not properly aligned. Please realign the tailstock to the headstock.
U
unobleAug 20, 2025
What to do if the quill will not move forward into workpiece on my Grizzly Lathe?
- L
  Lisa AcostaAug 20, 2025
  If the quill won't move forward when you turn the handwheel, it might be because the keyway is not aligned with the quill lock lever. Align the quill keyway with the quill lock lever and slightly tighten the lever to engage the keyway.