To Next Page

To Previous Page

"'%"

BdYZa<%*&+B[\#-$%+ 

3. >chZgi i]Z ZcY d[ i]Z YZVY XZciZg ^cid i]Z

iV^ahidX`WVggZa!Vhh]dlc^cFigure 18!jci^a

^i hZVih i^\]i Zcdj\] i]Vi ^i l^aa cdi gdiViZ

l]Zc ijgcZY Wn ]VcY# Note—do not worry

about pushing the dead center into the barrel

too far. The force of the center contacting a

mounted workpiece will fully seat the taper

when the handwheel is tightened.

4. I^\]iZci]ZWVggZaadX`idegZkZcii]ZiV^ahidX`

WVggZa[gdbbdk^c\Yjg^c\deZgVi^dc#

Figure 18.>chZgi^c\YZVYXZciZg^cid

iV^ahidX`WVggZa#

Adjusting Tailstock

Longitude Position

I]ZiV^ahidX`dci]ZBdYZa<%*&+XaVbehidi]Z

WZY l^i] i]Z cji h]dlc ^c Figure 19# I]^h cji

Vaadlhi]ZiV^ahidX`idWZedh^i^dcZYadc\^ijY^cVaan

Vadc\i]ZWZYVcYi]ZcadX`ZY^ceaVXZ#

To adjust the tailstock longitude position:

1. JhZ V &,bb lgZcX] id addhZc i]Z iV^ahidX`

XaVbeWdai#

2. L^i]ndjg]VcYh!bdkZi]ZiV^ahidX`^cidedh^"

i^dcVadc\i]ZWZY#

3. I^\]iZci]ZiV^ahidX`XaVbeWdaiidhZXjgZi]Z

iV^ahidX`^cidedh^i^dc#

Figure 19.IV^ahidX`XaVbeWdai#

Removing Tailstock

Dead Center

To remove the tailstock dead center:

1. JhZi]ZWVggZa]VcYl]ZZaidbdkZi]ZiV^ahidX`

WVggZaVaai]ZlVnWVX`^cidi]ZiV^ahidX`jci^a

i]Z]VcYl]ZZal^aacdadc\Zgijgc#

2. Ejaai]ZYZVYXZciZgdjid[i]ZiV^ahidX`WVg"

gZa#

Grizzly G0516 Owner's Manual

Other manuals for Grizzly G0516