To make a rip cut:
1. Preventing Kickback Page
13
2.
3.
4.
5.
6.
7.
8.
9.
ON,
Ripping
Serious injury can be caused by kickback.
Kickback is a high-speed expulsion of stock
from the table saw toward an operator. The
operator or bystanders may be struck by
flying stock, or the operator’s hands can be
pulled into the blade during the kickback.
Note: The jointed edge of the workpiece
must slide against the fence during the cut-
ting operation.
10.
Figure
59
Figure 59.
Turn OFF the saw and allow the blade to
come to a complete stop before removing
the cut-off piece. Failure to follow this warn-
ing could result in serious personal injury.
Keep the blade guard installed and in the
down position. Failure to do this could
result in serious personal injury or death.
To Next Page
Loading...
Need help?
General
