Clamping Pressure and Parallelism
Note:If the front end of the fence needs to
be adjusted up or down, use the set screws
from Figure 129; however, turn them in
even increments and recheck the square-
ness afterwards.
3.
4.
Figure 132.
To adjust the fence clamping pressure and
parallelism to the blade:
1.
2.
Figure 132
To verify fence parallelism:
1.
Figure 130 Page
75
2.
Figure 131
Figure 131.
;ZcXZ^h
EVgVaaZaid
B^iZgHadi!
l]^X]^h
EVgVaaZaid
7aVYZ
B^iZgHadi
7aVYZ
;ZcXZ
Figure 131
Miter Slot to Blade Parallelism
Page 71
To Next Page
Loading...
Need help?
General
