READ THIS FIRST
For questions or help with this product contact Tech Support at (570) 546-9663 or techsupport@grizzly.com
Model G0858
***IMPORTANT UPDATE***
For Machines Mfd. Since 07/19
and Owner's Manual Revised 06/19
COPYRIGHT © NOVEMBER, 2019 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#BL20773 PRINTED IN TAIWAN
The following changes were recently made since the owner's manual was printed:
• Machine is shipped without blade guard installed.
• Revised Assembly instructions on Page 21. The revised steps below replace existing Step 9.
IMPORTANT: YOU MUST INSTALL GUARD BEFORE OPERATING MACHINE THE FIRST TIME!
Aside from this information, all other content in the owner's manual applies and MUST be read and under-
stood for your own safety. IMPORTANT: Keep this update with the owner's manual for future reference.
For questions or help, contact our Tech Support at (570) 546-9663 or techsupport@grizzly.com.
Revised Assembly Steps
9. Set fence to 90° and move it all the way back.
10.
Remove pre-installed button head cap screw
and fender washer from bottom of cutterhead
guard shaft; then loosen shaft lock and insert
shaft into mounting hole, positioned so guard
rests against fence (see Figure 14).
12.
Verify proper operation of cutterhead guard
by setting fence to 90°, moving fence to rear
of table, then pulling cutterhead guard back
and letting it go. It should spring back over
cutterhead and contact fence without drag-
ging across outfeed table.
—
I f cutterhead guard does not spring back
over cutterhead and contact fence, or if it
drags across outfeed table, then it must
be adjusted (refer to Checking/Adjusting
Cutterhead Guard on
Page 53 for
instructions).
The cutterhead guard is a critical safety
feature of this jointer. You MUST verify its
operation before using the jointer! Failure
to properly install this guard will greatly
increase risk of serious personal injury.
11. Position guard height as low as possible with-
out dragging on infeed table/rabbeting ledge
(approximately
1
⁄16" above infeed table), tight-
en shaft lock to secure setting, then install
button head cap screw and fender washer.
Figure 14. Cutterhead guard components.
Cutterhead Guard
Fence
Shaft Lock
To Next Page
Need help?
General
