-38-
Model G0869/G0870 (Mfd. Since 01/19)
Workpiece
Fence
Blade
Figure 53. Example of second cut to create a
rabbet.
6. Reconnect saw to power source, then per-
form cut.
7. Lay workpiece flat on table, as shown in
Figure 53, adjust saw blade height to inter-
sect with first cut, then perform second cut to
complete rabbet.
DO NOT place a tall board on edge to per-
form a rabbet cut with a standard blade.
Workpieces that are too tall to properly sup-
port with fence can easily shift during oper-
ation and cause kickback. Instead, place
stock flat on saw and perform rabbet cut
with a dado blade, as instructed on Page 37.
45
To Next Page
Loading...
Need help?
General
