To Next PageTo Next PageWhat causes infeed roller marks on the workpiece from my Grizzly G1021?
Infeed roller marks are left on the workpiece of your Grizzly Planer when the depth of cut is too shallow. Increase the depth of cut.
How do I control snipe on my Grizzly G1021?
To control snipe on your Grizzly Planer, lift up on the unsupported end of the board as it enters and exits the cutter-head. Snipe is caused by long or heavy boards sagging as they enter and exit the planer.
General safety guidelines applicable to power tools.
Specific safety precautions for operating the planer.
Essential information regarding the planer's 220V power requirements.
Explanation of grounding importance and procedures for safety.
Guidelines for selecting and using appropriate extension cords.
General steps and tools required for planer assembly.
Instructions for assembling the optional planer stand.
Steps for mounting and connecting the starter switch to the planer.
Instructions for mounting and using the handwheel for table adjustment.
Introduction to planer adjustment controls and their locations.
Procedure for checking and adjusting table parallelism to the cutterhead.
Detailed guide for setting the planer knives for optimal cutting.
How to adjust feed roller pressure for proper workpiece feeding.
General safety practices and operational advice for using the planer.
Explanation of the planer's feed rates and speed control.
Steps for performing an initial test run to ensure proper operation.
Guidance on inspecting, sharpening, and maintaining planer knives.
Comprehensive guide to lubricating various components of the planer.
General safety guidelines applicable to power tools.
Specific safety precautions for operating the planer.
Essential information regarding the planer's 220V power requirements.
Explanation of grounding importance and procedures for safety.
Guidelines for selecting and using appropriate extension cords.
General steps and tools required for planer assembly.
Instructions for assembling the optional planer stand.
Steps for mounting and connecting the starter switch to the planer.
Instructions for mounting and using the handwheel for table adjustment.
Introduction to planer adjustment controls and their locations.
Procedure for checking and adjusting table parallelism to the cutterhead.
Detailed guide for setting the planer knives for optimal cutting.
How to adjust feed roller pressure for proper workpiece feeding.
General safety practices and operational advice for using the planer.
Explanation of the planer's feed rates and speed control.
Steps for performing an initial test run to ensure proper operation.
Guidance on inspecting, sharpening, and maintaining planer knives.
Comprehensive guide to lubricating various components of the planer.
General| Model | G1021 |
|---|---|
| Type | Planer |
| Number of Knives | 3 |
| Maximum Cutting Width | 15 inches |
| Maximum Cutting Depth | 1/8 inch |
| Dust Port Size | 4 inches |
| Feed Rate | 20 FPM |
| Feed Speed | 20 FPM |
