G1182 6" Series Jointers -9-
Model G1182ZX (Figure 2D)
Same as G1182Z above except the on/off switch
is replaced by a pedestal mounted electrical
switch assembly.
In the event that any non-proprietary parts are
missing (e.g. a nut or a washer), we would be glad
to replace them, or, for the sake of expediency,
replacements can be obtained at your local hard-
ware store.
Model G1182Z (Figure 2C)
• Jointer Assembly
• Fence Assembly
• Stand Assembly
• Dust Hood
• Hardware
-Hex Bolts
3
⁄8" - 16 x
3
⁄4"3
-Lock Washers
3
⁄8"3
-Allen
®
Wrench 3mm 1
-V-Belt 1
-Knife Setting Jig 1
-Tilt Lever 1
-Knob 1
-Locking Screw 1
-Flat Washer
1
⁄2" 1
-Special Nut 1
Figure 2C. G1182Z layout.
Figure 2D. G1182ZX layout.
To Next Page
Loading...
Need help?
General
