4 OM-DH/DHT
The Groen DH is a floor-mounted, tilting, steam jacketed kettle with a thermostatically or
electronically controlled, self-contained, gas-heated steam source and appropriate controls,
mounted on a sturdy base. The Model DH is available in 20, 40, 60 or 80 gallon capacities.
The body of the DH Kettle is constructed of stainless steel, welded into one solid piece.
The kettle is furnished with a reinforced rim and a butterfly shaped pouring lip. It has a
steam jacket which is ASME shop inspected and registered with the national board for
working pressures up to 50 PSI. Kettle finish is 180 emery grit on the inside and bright
high buff polish on the outside.
The kettle is tilted with a hand crank to pour out its contents. Stainless steel panels
enclose the controls and the base. Four stainless steel tubular legs support the unit.
Bullet or flanged feet on each of the legs can be adjusted to level the kettle. Standard
DHT units include a two inch tangent draw-off valve.
The self-contained steam source is heated by propane or natural gas. Ignition is
electronic.
The kettle is charged at the factory with chemically pure water which contains rust
inhibitors. The steam source provides kettle temperatures of 150º to approximately
295ºF (65 to 150ºC). Unit controls include a thermostat or controller, pressure gauge,
safety valve, pressure limit control, low water cut-off, power switch and gas regulator
valve. The gas supply shuts off automatically when the kettle is tilted.
The unit must be specified for use with natural or propane gas. Service connections for
gas and electricity are required. Standard power supply is 115 Volt. Alternate single-
phase voltages (208-240V) are available.
Available Options:
1. Two inch tangent drawoff standard on DHT models
2. Strainers, solid disk, 1/4 or 1/8 inch holes
3. No. 31 lift-off cover
4. No. 51 counterbalanced cover w/actuator*
5. Basket Inserts (Tri-BC)
6. Water fill faucets with swing spout
7. Kettle Brush Kit
Equipment Description
KETTLE CHARACTERISTICS
DH/DHT-20 DH/DHT-40 DH/DHT-60 DH/DHT-80
Kettle
Capacity
20 gal.
(75 ltr)
40 gal.
(150 ltr)
60 gal.
(225 ltr)
80 gal.
(302 ltr)
Kettle Body Diameter
20 in.
(508 mm)
26 in.
(660 mcm)
30 in.
(762 mm)
34 in.
(863 mm)
Base Width
35 in.
(889 mm)
47 in.
(1194 mm)
47 in.
(1194 mm)
52 in.
(1320 mm)
Base Front to Back
29 in.
(736 mm)
29 in.
(736 mm)
29 in.
(736 mm)
37.5 in.
(952 mm)
Firing Rater Per Hour
72,000 BTU 100,000 BTU 150,000 BTU 150,000 BTU
Energy into Product
Per Hour
44,140 BTU 65,000 BTU 93,000 BTU 93,000 BTU
To Next Page
Loading...
Need help?
General
