6
1. Partially open the on/off air valve (It helps in creating initial vacuum when filling a totally dry pump). Pump will start operating
automatically until it gets primed. Pump is said to be Primed when grease is available at the pump outlet, making the pump ready to use.
Once primed, the air motor will stop. Open the on/off air valve fully.
2. Hold the grease control valve near a container & press the trigger. Pump will start
operating with continuous grease discharge as long as the trigger is pressed. Release
the trigger & this will stop the pump. Check for any leaks from any of the connections &
Tighten again if required.
3. Connect coupler fitted onto the control valve extension with the grease nipple & press trigger. Be careful not to over-lubricate as the pump
will keep dispensing grease as long as the trigger is pressed. Once the trigger is released, pump will stop dispensing grease & the air
motor will stop.
4. When not in use & at the end of each day, air supply to the pump must be switched off.
PUMP OPERATION
To Next Page
Loading...
Need help?
General
