English (GB)
17
00011 ScadaPinCode
PIN code for SCADA systems, etc.
If GeneralStatus.ScadaPinCodeEnabled (register 00029, bit 0) is
enabled, the correct PIN code must be entered in this register in order to
gain access to remote control and configuration.
Verify acceptance in GeneralStatus.WriteAccess (register 00029, bit 1).
Programming of the SCADA PIN code made via the SMS command
SETSCADACODE. See "CIM 250 SMS commands" (supplement to
installation and operating instructions) on the CD-ROM supplied with the
GSM module.
●●●
Address Register name Description
CIM
200
CIM
250
CIM
500
To Next Page
Loading...
