Grundfos MGE-F - Indicator Lights; R100 Remote Control

8 / 32
2.3 Indicator lights
2.3.1 Indicator lights on the control panel
The indicator lights on the control panel show the MGE-F motor's operating and alarm condition.
2.3.2 Indicator lights inside the terminal box
The indicator lights beside the terminal block on the control board normally have the same functions as the indicator
lights on the control panel. See fig. 14.
See section 3.5 Fault finding using the indicator lights on the control panel to get an overview of the meaning of the
indicator lights.
2.4 Setting using the R100 remote control
The Grundfos R100 remote control is designed for wireless (IR) communication with the Grundfos E-products, including
the MGE-F.
Fig. 15 The R100 communicates with the motor via infrared light
During communication, the R100 must be pointed at the control panel. When the R100 communicates with the motor,
the red indicator light will flash rapidly. Keep pointing the R100 towards the control panel until the red indicator light stops
flashing.
The R100 gives access to settings and status displays for the motor.
The displays are divided into four parallel menus. See fig. 16:
0. GENERAL (see operating instructions for the R100)
1. OPERATION
2. STATUS
3. INSTALLATION.
Note
In case of certain faults in the electronics, the indicator lights on the control panel may indicate
differently from the indicator lights on the control board. In these cases, the indicator lights on
the control board indicate the current operating and alarm condition.
TM04 2569 2708
Fig. 14 Indicator lights inside the terminal box
TM02 0936 0501
Indicator lights for operation and alarm on the control board