Grundfos MGE Series User Manual

English (GB)
28
Settings MGE
Multimotor
system
Section Page
"Setpoint" ●●10.1 ""Setpoint"" 32
"Operating mode" ●●10.2 ""Operating mode"" 32
"Control mode" ●●10.4 "Control mode" 32
"Pipe-filling function" ●●10.16 "Ramps" 42
"Buttons on product" ●
10.27 "Buttons on product"
(""Enable/disable settings"")
43
"Controller" ●●
10.11 "Controller" (""Controller
settings"")
37
"Operating range" ●●10.12 ""Operating range"" 37
"Ramps" ● 10.16 "Ramps" 42
"Number" ● 10.22 "Number" (""Pump number"") 43
"Radio communication" ●
10.23 "Radio communication"
(""Enable/disable radio comm."")
43
"Analog input 1" ●
10.5 ""Analog inputs"" 32"Analog input 2" ●
"Analog input 3"
1)
●
"Pt100/1000 input 1"
1)
●
10.6 ""Pt100/1000 inputs"" 33
"Pt100/1000 input 2"
1)
●
"Digital input 1" ●
10.7 "Digital inputs" 34
"Digital input 2"
1)
●
"Digital in/output 3" ●
10.8 ""Digital inputs/outputs"" 35
"Digital in/output 4"
1)
●
"Predefined setpoint" ●●10.14 "Predefined setpoints" 40
"Analog output"
1)
● 10.10 ""Analog output"" 36
"External setpoint
function"
● 10.13 ""External setpoint function"" 37
"Signal relay 1" ●
10.9 "Signal relay" (""Relay outputs"") 36
"Signal relay 2" ●
"Limit 1 exceeded" ●●
10.15 ""Limit-exceeded function"" 41
"Limit 2 exceeded" ●●
"Alternating operation,
time"
2)
●
10.42 ""Setup of multi-pump system""
(Multimotor)
46
"Time for pump
changeover"
1) + 2)
●
1)
Only available if an advanced functional module, type FM 300, is fitted.
Continued on page 29.

Grundfos MGE Series Specifications

General

Brand	Grundfos
Model	MGE Series
Category	Engine
Language	English