Grundfos MGE Series - Page 29

English (GB)
29
1)
Only available if an advanced functional module, type FM 300, is fitted.
2)
Only available if Grundfos GO is connected to a multimotor system.
Continued from page 29.
Settings MGE
Multimotor
system
Section Page
"Standstill heating" ● 10.19 ""Standstill heating"" 42
"Motor bearing
monitoring"
● 10.20 ""Motor bearing monitoring"" 42
"Service" ● 10.21 "Service" 43
"Date and time"
1)
●
10.25 "Date and time" (""Set date and
time"")
43
"Store settings" ●
10.31 "Store settings" (""Store actual
settings"")
44
"Recall settings" ●
10.32 "Recall settings" (""Recall stored
settings"")
44
"Undo" ●●10.32.1 "Undo" 44
"Pump name" ●●10.33 "Pump name" (motor name) 44
"Connection code" ●●10.34 "Connection code" 44
"Unit configuration" ● 10.26 "Unit configuration" (""Units"") 43
Alarms and warnings MGE
Multimotor
system
Section Page
"Alarm log" ●●10.36 ""Alarm log"" 45
"Warning log" ●●10.37 ""Warning log"" 45
"Reset alarm button" ●●
Assist MGE
Multimotor
system
Section Page
"Assisted pump setup" ●
10.39 ""Assisted pump setup""
(Assisted motor setup)
45
"Assisted fault advice" ●●10.44 ""Assisted fault advice"" 49
"Multipump setup" ●●
10.42 ""Setup of multi-pump system""
(Multimotor)
46