Grundfos Peerless Pump 8196 Series - Ordering Spare Parts; Recommended Spare Parts; Instructions for Ordering Spare Parts

ORDERING SPARE PARTS
To insure against possible long and costly downtime periods, especially on critical services, it is advisable to
have spare parts on hand.
1.
For critical services: It is recommended that a "back pull-out assembly" be kept on hand. This is a
group of assembled parts which includes all parts except the casing and the coupling.
(a). If pump is equipped with mechanical seal, the following parts should be on hand:
(1) Stuffing box packing.
(2 ) Stuffing box gland.
2.
An alternative, though not as desirable as that stated above, can be used on noncritical services. This
involves having on hand parts that are most likely to wear and can be used as needed. See list below
for these recommended spares.
Recommended Spare Parts
Shaft
Item 122
Bearing Housing Snap Ring
Item361A
Shaft Sleeve
Item 126
Bearing Lock Washer
ltem382
Outboard Bearing
ltem112
Bearing Lock Nut
Item 136
Inboard Bearing
Item 168 A
Impeller
Item 101
Case Gasket
ltem351
Shaft Sleeve 0-Ring
ltem496A
Frame/Adapter 0-ring
ltem360D
Lantern Ring ( packed box)
Item 105
Bearing Housing 0-ring
ltem496
Bearing Cover Gasket (XLTP only)
Item360C
Instructions for Ordering Spare Parts
Repair orders will be handled with a minimum of delay. Contact your local authorized representative and
provide the following:
1.
Give model number, size of pump, and serial number. These can be obtained from the nameplate on
the pump.
2.
Write plainly the name, part number, and material of each part required. These names and numbers
should agree with those on the sectional drawing on pages43,44,45 and46.
3. ·
Give the number (quantity) of parts required.
4.
Give complete shipping instructions.
NOTICE
Materials of construction, specifications, dimensions, design features and application information,
where shown in this bulletin, are subject to change without notice by Peerless Pump Company at
their option.
4852840 Page 49