This instruction manual is intended to assist those involved with the installation, operation and maintenance. of Peerless
Pump Company
ANSI Process Pumps. It is recommended that this manual be thoroughly reviewed prior to installing or
performing any work on the pump or motor.
I·A. IMPORTANCE OF INSTRUCTIONS
The design, material and workmanship incorporated in the construction of pumps by Peerless Pump Company
them capable of giving long, trouble-free service. The life and satisfactory service of an
y mechanical unit, however, is
enhanced and extended by periodic inspection and careful maintenance. This instruction manual was prepared to assist
operators in understanding the construction and correct methods of installing, operating, and maintaining th
Thoroughly study Sections I, II, III and carefully follow the instruc
tions for installation. Sections IV and V have answers
to trouble and maintenance questions. Keep this instruc
tion manual handy for reference. Further information can be
obtained by contacting the local authorized distributor or the factory.
Peerless Pump Company will not be liable for any damages or delay caused by failure to comply with the
provisions of this instruction manual. This pump is not to be operated at speeds, working pressures, discharge
pressures, or temperatures higher than, nor used with liquids other than, stated in the original order
acknowledgment without written permission of Peerless Pump Company. For Pressure/Temperature limitations
I-C. RECEIVING INSPECTION-SHORTAGES
Care should be taken when unloading pumps. If shipment is not delivered in good order and in accordance with the
Bill-of-Lading, note the damage or shortage on both receipt and freight bill.
TRANSPORTATION COMPANY PROMPTLY.
Instruction sheets on various components as well as the Instruction
Book for the pump are included in the shipment. DO NOT DISCARD!
I-D. PRESERVATION AND STORAGE
Peerless Pump Company normal domestic shipping and storage preparation is suitable for protect
ing the pump during
shipment in covered trucks. It also provides protection during covered storage at the job site, and for a short period
between installation and start-up. If the pump is t
o be idle and/or exposed to the elements for an extended period, either
before or after installation, special precautions are required. One ap
proach is to provide special preservatives and
wrapping before shipment. However, after installation the protect
ive wrappings will have been removed. Therefore,
application of preservatives after installation is considered a good practice. Information about various long term
preservation and storage options available can be obtained for the driver, coupling, mechani
cal seal, or other equipment
supplied on your order. Contact the factory for further details.
To Next Page
Loading...
