EasyManua.ls Logo

Grundfos RSI - Page 123

Grundfos RSI
182 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8.1.18 Group 3.22: Solar
Group 3.22.1: Start Settings
Code Parameter Min Max Unit Default ID Description
P3.22.1.1 Start DC voltage
P3.22.2.16
+ 5 V
1100 V Varies 1916
DV voltage threshold level
to activate Run enable
P3.22.1.2 Short restart delay 0.1 5.0 m 1.0 1917 Delay time to restart
P3.22.1.3 Short restart delay tries 1 10 5 1918 Number of restart tries
P3.22.1.4 Long restart delay 6.0 30.0 m 10.0 1919 Long delay time to restart
P3.22.1.5 Sleep in solar mode Disabled Enabled Disabled 1964
0 = Sleep disabled
1 = Sleep according to
P3.13.5.1 and P3.13.5.2
Sleep in solar mode can be managed
according to P3.13.5.1 and P3.13.5.2.
When P3.22.1.5 =1, the drive will stop if
the output frequency is below the value in
P3.13.5.1, for the time in P3.13.5.2. It will
restart as after a stop due to low power.
Sleep function allows to program a
minimum frequency P3.3.1.1 that is below
the efficient range of the pump. MPPT can
reach this low value, leading to a minimum
output power and avoiding to stop the
drive in case of temporary reduced
irradiation. If the condition persists, sleep
logic will then stop the drive.
Group 3.22.2: MPPT
Code Parameter Min Max Unit Default ID Description
P3.22.2.1 Vmp at 100 % power
P3.22.
2.16 +
5 V
1100 V Varies 1920
P3.22.2.2 Vmp at 10 % power
P3.22.
2.16 +
5 V
1100 V Varies 1921
P.14.2.3 Panel/Motor power ratio 50.00 100.00 % 100.00 1922
P3.22.2.4 P gain 0.000 1.000 0.050 1923
Gain for internal PI regulator. The
internal frequency reference keeps
the panels working on MPP.
P3.22.2.5 I gain 0.000 1.000 0.050 1924 Integration time.
P3.22.2.6 Acceleration time 0.1 60.0 s 1.0 1925
Time from minimum to maximum
frequency
P3.22.2.7 Deceleration time 0.1 60.0 s 1.0 1926
Time from maximum to minimum
frequency
P3.22.2.8 P&O update time 2 6 s 3 1939
P3.22.2.9 P&O voltage step 3 10 V 5 1940
P3.22.2.10 P&O power variation 0.2 5.0 % 1.0 1941
P3.22.2.11 P&O local max volt step 20 60 V 30 1945
P3.22.2.12 P&O local max time 1 60 m 10 1946
P3.22.2.13 P&O local max freq 0.00 20.00 Hz 10.00 1947
123
English (GB)

Other manuals for Grundfos RSI

Related product manuals