Grundfos RSI - Installation; Danger; Warning

3.1.4 Lifting RSI drive module MR10 with an options module
≤60°
TM083243
Lifting RSI drive module MR10 with an options module
1. Remove the drive from the package.
2. Use a lifting device that is sufficiently strong for the weight of the drive.
3. Put the lifting hooks in the holes on the top of the cabinet. The maximum lifting angle is 60°.
4. Lift the drive into a vertical position.
4. Installation
The installation instructions in this chapter are
intended only for RSI (A-C) and RSI (MR5-MR10)
drives with additional solar pump application. See the
corresponding operating guide/installation manual for
more installation instructions.
4.1 Danger
DANGER
Electric shock
Death or serious personal injury
‐ The terminals are live when the drive is
connected to a photovoltaic system.
Photovoltaic cells generate DC voltage
even at low intensity of sunlight.
DANGER
Electric shock
Death or serious personal injury
‐ Wait 60 seconds until the drive is
discharged, before switching between
AC and DC supply (photovoltaic
system) and vice versa.
4.2 Warning
WARNING
Electric shock
Death or serious personal injury
‐ Do not remove the EMC screws in the
solar pump application. IT (impedance-
grounded) AC supply network is not
allowed in the solar pump application.
10
English (GB)