Grundfos RSI - Page 9

1. Remove the drive from the cardboard box or the pallet where it was bolted to.
2. Use a lifting device that is sufficiently strong for the weight of the drive.
3. Put the lifting hooks symmetrically in a minimum of 2 holes.
4. The maximum lifting angle is 45°.
3.1.3 Lifting RSI drive module MR10 without options
A
A
TM083242
Lifting RSI drive module MR10 without options
1. Remove the drive from the package.
2. Make sure that the support (A in fig. Lifting RSI drive module MR10 without options) is attached to the bottom
of the drive. It gives the terminals protection when you lift the drive or put it vertically on the floor.
3. Use a lifting device that is sufficiently strong for the weight of the drive.
4. Put the lifting hooks in the holes on the top of the cabinet. The maximum lifting angle is 60°.
5. After the lifting, you can remove the support if necessary. You can also use it as a fixing bracket.
9
English (GB)