Grundfos RSI - Parameters; Application Parameter Lists

8. Parameters
RSI contains a pre-loaded Grundfos motor library for
instant use. The parameters of this application are
listed in this chapter.
Advanced password
RSI is designed to fit into solar applications, and
some parameters are hidden by a password
(681400). It can be entered in the quick setup under
"Advanced password". Then you get full access to all
the parameters.
Changing the parameters can influence
the MPPT and may cause it to
malfunction.
Related information
6.2.3 Parameters
8.1 Application parameter lists
Find the parameter menu and the parameter groups
as guided below.
Main Menu

Quick Setup
( 17 )

( 6 )
Monitor

ID: M3
STOP READY Keypad
Parameters
( 13 )

STOP READY Keypad




Motor Settings
( 2 )
Start/Stop Setup
( 7 )
References
( 18 )
Parameters
ID: M3.1
OK
TM078686
RSI embodies the following parameter groups:
Menu and Parameter group Description
Group 3.1: Motor settings Basic and advanced motor settings
Group 3.2: Start/Stop setup Start and stop functions
Group 3.3: References Parameters for setting references and preset speeds.
Group 3.4: Ramps And Brakes Acceleration/Deceleration setup
Group 3.5: I/O Config I/O programming
Group 3.6: Fieldbus DataMap Process data in/out mapping
Group 3.7: Prohibit Frequencies Prohibit frequencies programming
Group 3.8: Supervisions Programmable limit controllers
Group 3.9: Protections Protections configuration
Group 3.10: Automatic reset Auto reset after fault configuration
Group 3.11: Appl. Settings Application settings
Group 3.12: Timer functions Configuration of 3 timers based on Real Time Clock.
Group 3.13: PID Controller Parameters for PID Controller 1.
Group 3.14: ExtPID Controller Parameters for external PID Controller.
Group 3.16: Maintenance Counters Parameters related to Maintenance counters.
Group 3.21: Pump Control Pump function parameters
72
English (GB)