Grundfos RSI - Page 71

Code Monitoring value Unit Scale ID Description
V2.12.11 FB Status Word 1 864
Fieldbus status word sent by application in bypass mode/
format. Depending on the FB type or profile the data can
be modified before sent to the FB.
V2.12.12 FB Speed Actual 0.01 865
Actual speed in %. 0 and 100 % correspond to minimum
and maximum frequencies respectively. This is
continuously updated depending on the momentary min
and max frequencies and the output frequency.
V2.12.13 FB data out 1 1 866 Raw value of process data in 32-bit signed format
V2.12.14 FB data out 2 1 867 Raw value of process data in 32-bit signed format
V2.12.15 FB data out 3 1 868 Raw value of process data in 32-bit signed format
V2.12.16 FB data out 4 1 869 Raw value of process data in 32-bit signed format
V2.12.17 FB data out 5 1 870 Raw value of process data in 32-bit signed format
V2.12.18 FB data out 6 1 871 Raw value of process data in 32-bit signed format
V2.12.19 FB data out 7 1 872 Raw value of process data in 32-bit signed format
V2.12.20 FB data out 8 1 873 Raw value of process data in 32-bit signed format
7.1.11 Solar
Code
Monitoring
value
Unit Scale ID Description
V2.15.1 Vmp ref V 1914 DC voltage reference for MPP regulation
V2.15.2 Vmp ref correct V 1942
Present correction on DC voltage reference
(P&O + oscillation)
V2.15.3 Motor Power kW 1938 Motor shaft power
V2.15.4 Energy counter MWh 1937 Counter of energy taken by the supply
B2.15.5
Energy counter
reset
1932 To reset V2.15.4
V2.15.6
Irradiation
measure
W/m
2
1982 Measurement from irradiation signal
7.1.12 Flow
Code Monitoring value Unit Scale ID Description
V2.16.1 Actual flow l/min 1956
Actual flow: it is measured by
transducer define with P3.23.1
V2.16.2
Volume counter 1
3)
m
3
1955 Cumulative water volume counter.
V2.16.3
Volume counter 2
3)
10
4
x m
3
1962 Cumulative water volume counter.
B2.16.4
Volume counters
reset
1961 To reset V2.16.2 and V2.16.3
3)
The total volume of water in [m
3
] is given by: V2.16.2 + (V2.16.3 x 10000).
71
English (GB)