Grundfos RSI - Page 80

Code Parameter Min Max Unit Default ID Description
P3.2.10 Rem to Loc Funct 0 2 2 181
Choose whether to copy the Run state
and Reference when changing from
Remote to Local (keypad) control:
0 = Keep Run
1 = Keep Run & Reference
2 = Stop
P3.2.11 Start Analogue Signal 0 1 0 1810
0 = AI1
1 = AI2
P3.2.12 Start Analogue Level 0.00 100.00 % 10.00 1857
Start is set below this level (unscaled
signal). Start-stop logic is reversed if >
P3.2.13
P3.2.13 Stop Analogue Level 0.00 100.00 % 80.00 1856
Start is set above this level (unscaled
signal). Start-stop logic is reversed if <
P3.2.12
8.1.4 Group 3.3: References
Frequency reference
The frequency reference source is programmable for
all control places except PC, which always takes the
reference from the PC tool.
Remote control place (I/O A): The source of
frequency reference can be selected with parameter
P3.3.1.5.
Remote control place (I/O B): The source of
frequency reference can be selected with parameter
P3.3.1.6.
Local control place (Keypad): If the default
selection for parameter P3.3.1.7 is used the reference
set with parameter P3.3.1.8 applies.
Remote control place (Fieldbus): The frequency
reference comes from fieldbus if the default value for
parameter P3.3.1.10 is kept.
Code Parameter Min Max Unit Default ID Description
P3.3.1.1 MinFreqReference 0.00 P3.3.1.2 Hz 0.00 101
Minimum allowed frequency
reference
P3.3.1.2 MaxFreqReference P3.3.1.1 320.00 Hz 50.00 102
Maximum allowed frequency
reference
P3.3.1.3 PosFreqRefLimit -320.0 320.0 Hz 320.00 1285
Final frequency reference limit for
positive direction.
P3.3.1.4 NegFreqRefLimit -320.0 320.0 Hz -320.00 1286
Final frequency reference limit for
negative direction.
Note: This parameter can be used
e.g. to prevent motor from running in
reverse direction.
80
English (GB)