Grundfos RSI - Page 157

8.2.18 Sleep Function
P3.13.5.1 SP 1 Sleep frequency limit 1
P3.13.5.2 SP 1 Sleep Delay
P3.13.5.3 SP 1 WakeUpLevel
This function will put the drive into sleep mode if the
frequency stays below the sleep limit for a longer time
than that set with the Sleep Delay (P3.13.5.2). This
means that the start command remains on, but the
run request is turned off. When the actual value goes
below, or above, the wake-up level depending on the
set acting mode the drive will activate the run request
again if the start command is still on.
1
2
3
4
5
6
6
7
9098
Sleep limit, Sleep delay, Wake-up level
Pos. Description
1 Actual value
2 Wake-up level (ID1018)
3 Frequency
4 Sleep delay (ID1017)
5 Sleep limit (ID1016)
6 Regulating mode
7 Sleep
157
English (GB)