9.4.74 Code 109 (Fault ID 1109, Input pressure supervision)
Cause Remedy
Input pressure supervision signal is below the alarm
limit.
• Check the process.
• Check the parameters.
• Check the input pressure sensor and the
connections.
9.4.75 Code 109 (Fault ID 1409, Input pressure supervision)
Cause Remedy
Input pressure supervision signal is below the fault
limit.
• Check the process.
• Check the parameters.
• Check the input pressure sensor and the
connections.
9.4.76 Code 111 (Fault ID 1315, Temperature fault 1)
Cause Remedy
At least one of the selected temperature input signals
has reached the alarm limit.
• Find the cause of the temperature raise.
• Check the temperature sensor and the connections.
• Check that the temperature input is hard-wired if a
sensor is not connected.
• For further information, see the option board
manual.
9.4.77 Code 111 (Fault ID 1316, Temperature fault 1)
Cause Remedy
At least one of the selected temperature input signals
has reached the fault limit.
• Find the cause of the temperature raise.
• Check the temperature sensor and the connections.
• Check that the temperature input is hard-wired if a
sensor is not connected.
• For further information, see the option board
manual.
9.4.78 Code 112 (Fault ID 1317, Temperature fault 2)
Cause Remedy
At least one of the selected temperature input signals
has reached the alarm limit.
• Find the cause of the temperature raise.
• Check the temperature sensor and the connections.
• Check that the temperature input is hard-wired if a
sensor is not connected.
• For further information, see the option board
manual.
9.4.79 Code 112 (Fault ID 1318, Temperature fault 2)
Cause Remedy
At least one of the selected temperature input signals
has reached the fault limit.
• Find the cause of the temperature raise.
• Check the temperature sensor and the connections.
• Check that the temperature input is hard-wired if a
sensor is not connected.
• For further information, see the option board
manual.
178
English (GB)
To Next Page
Loading...
