Grundfos TPE - Page 20

English (GB)
20
Settings Section Page
Setpoint 10.1
Setpoint 21
Operating mode 10.2
Operating mode 21
Control mode 10.4 Control mode 21
Date and time
Buttons on product
Controller 10.11
Controller settings 26
Operating range 10.12
Operating range 27
Ramps 10.15.2
Ramps 30
Pump number 10.16.1
Pump number 30
Radio communication
Analog input 1
10.5
Analog inputs 24Analog input 2
Analog input 3
Pt100/1000 input 1
10.6
Pt100/1000 inputs 24
Pt100/1000 input 2
Digital input 1
10.7
Digital inputs 25
Digital input 2
Digital in/output 3
10.8
Digital inputs/outputs 25
Digital in/output 4
Predefined setpoint 10.13.2
Predefined setpoints 30
Analog output 10.10
Analog output 26
External setpoint funct. 10.13.1 External setpoint influence 27
Signal relay 1
10.9
Relay outputs 26
Signal relay 2
Limit 1 exceeded
10.14.1
Limit-exceeded function 30
Limit 2 exceeded
Standstill heating
Motor bearing monitoring
Service
Reset to factory settings
Store settings
Recall settings
Undo
Pump name
Unit configuration
Alarms and warnings
Alarm log
Warning log
"Reset alarm" button
Assist
Assisted pump setup
Assisted fault advice
Multi-pump setup
Product information
Product information