Grundig VISION 9 42-9870 T - Information; Displaying Signal Information

ENGLISH
55
Displaying signal information
(only for digital television channels)
1 Open the menu with »i«.
– The »PICTURE« menu appears.
2 Select the menu »SETUP« with » V « or » Λ « and press »G« to con-
firm.
3 Select the menu »Digital Features« with » V « or » Λ « and press
»
G« to confirm.
4 Select »Signal Information« with » V « or » Λ « and press »G« to
confirm.
– You will see information on the frequency, modulation, quality
and signal strength.
Notes:
The lower section of the menu shows the signal properties. The
further the bar for »Quality« and »Signal Strength« extends to
the right, the better the reception signal.
The signal level not only depends on your receiver system, but
also on the channel which is currently active. Remember this when
aligning your antenna using the signal level display.
5 Press »i« to end the display.
INFORMATION
------------------------------------------------------------------------------
DIGITAL FEATURES
Language Settings
CA-Module No Module
Signal Information
e
Digital Reset
Back Enter Close
1