22
Same to Ignition system, put on Ignition LED. Then start
engine and make speed up to 7500 to 8000 rpm, system
works well if LED reach at standard position.
Engine
Engine Body
Low speed and speed up condition
Start engine without transmission
[Warm condition]
Adjust idle screw and set idle speed according standard value:
1600 ± 10％
If idle condition is not steady, please adjust vent screw.
Replacement of air filter core
Open six clips and take off air filter cover.
Take off filter core
Change filter core if it is dirty or damaged.
Standard period of change filter core：per 4000 KM
If road condition is not good, you should change filter core early
Lubricating System
Standard Position
Note: idle speed adjustment shall be made when the engine is
warmed up. And Carburetor adjustment following inspection
shall be made after adjustment of the airscrew.
Idle Screw
Air filter screws
Clips
Filter Core
Caution: since the filter paper of the filter core contains
oil (viscous); it cannot clean with air.
To Next Page
Loading...
