Guardall px - Page 36

PX/QX/RX Version 4.20 User Manual – Issue B
- 36 -
Alarm & Event Log messages
Log Text Additional Data Display Text Event Description
Det Test Fail Usnn, Area m Usnn, Am One or more detector test
circuits failed
Det Test OK Usnn, Area m Usnn, Am All detector test circuits tested
OK
Det.Test Fail User nn, Circuit mmm Usnn Cctmmm A detector circuit has failed to
respond during a detector test.
Dorm Confirm Circuit nnn Cctnnn Dormitory circuit confirmed
Dorm Init. Circuit nnn Cctnnn Dormitory circuit first activation
Download Fail GSRx GSRx Download from GSR x failed
Download OK GSRx GSRx Download from GSR x OK
Enc.Sequence User nn Usnn Encryption sequence fail
Engineer Reset Circuit nnn Cctnnn Engineer reset type circuit
alarms
Entry Alarm Area n An The area is not unset before the
end of the entry warning period
Entry Started Circuit nnn Cctnnn Entry circuit opens
Expiry Date Usnn Usnn Config change: User expiry date
change.
Ext.Time User nn, Keypad m Usnn, KPm ATM user selected a time
extension
Failed Auto Set User nn, Area m Usnn, Am
Event programmer failed to auto
set due to circuits in alarm
Fault Radio module number RM nn
Radio Module fault (no response
when unset). The system fault
response option must be
programmed. This option is only
available in EN50131 compliant
variants.
Fault Circuit nnn Cctnnn A Circuit short circuit when unset
Fault Keypad n KPn Failed poll when unset
Fault Conc nn Conc nn Failed poll when unset
Fault OPM nn OPM nn Failed poll when unset
Fault SM n SM n Failed poll when unset
Fault ACM nn ACM nn Failed poll when unset
Fire Circuit nnn Cctnnn A fire type circuit alarm
Fire Door Open Circuit nnn Cctnnn Fire door open when unset
First code User nn, Keypad m Usnn, KPm
User entered code on Dual code
keypad
GSM Route Fail NONE NONE A call using the Dual comm
GSM route has failed.
GSM Route OK NONE NONE A call using the Dual comm
GSM route was successful.
GSR Poll Fail GSRx GSRx GSR number x poll fail.
GSR Poll Rest. GSRx GSRx GSR number x polling restarted
GSR Rejected NONE NONE A call from an unauthorised
GSR was rejected by the panel
(the serial number was not
programmed)
Head Count Number Number of activations of all
circuits programmed with the
head count option while the
panel was unset.
Incorrect PIN Keypad n KPn Maximum PIN attempts reached
Isol. Limit Area n An The isolate limit for the system
has been reached.
Isolate User nn, Circuit mmm Usnn Cctmmm Circuit isolated by user
Isolate User nn, Concm Usnn, m Concentrator isolated by user
Isolate User nn, Keypad m Usnn, KPm Keypad isolated by user