EasyManua.ls Logo

Guldmann GL5 .2 - Troubleshooting Guide; Common Lifter Issues and Solutions

Default Icon
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
20
© Guldmann GB/US-04/2023 • # 561577_102
© Guldmann GB/US-04/2023 • # 561577_102
If other chemicals and/or liquids with higher resolution should be used to clean
or disinfect these products, please contact Guldmann providing the item´s safety
sheet chemical composition for consideration.
Caution: Take great care to ensure that no liquids get inside the lift. The lift is
not waterproof. Failure to protect the lift from liquids may result in damage to
the lift and/or may cause personal injury.
9.00 Troubleshooting
Error:
Lifter does not react to input from the buttons on the hand control.
1. Does the green or yellow LED on the hand control light up when the
control buttons are activated?
Yes see point 6.
No no light visible – see point 2.
No only yellow light visible – see point 3.
No yellow service light visible or audible “Beep”– see “indicator and audio
signals matrix”
2. Is the battery mounted on the lifter?
Yes see point 4.
No install a fully charged battery.
3. Is a battery with su󰀩cient charge installed in the lifter?
No install a fully charged battery or charge the battery.
4. Is the emergency stop activated?
Yes To release the emergency stop, take o󰀨 battery by using thumb and
index/middle nger to push buttons on battery sides, and pull battery
out.
To replace the battery again, grab battery on sides and steer battery
base on steering pin, and push in place.
No see point 5
5. Is the connector for the hand control tted in the lifter, and is the lifter
reacting to the buttons located on the control box?
Yes replace hand control
No t connector

Related product manuals