12
FUNCTION INTRODUCTION &
INSTRUCTIONS FOR USE
① MENU ：
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
DMX SETTINGS (Figure 1):
Set the DMX parameters, [address (001-512)]
and configure the mode [(8bit/16bit)].
DIM CURVE (Figure 2):
Set the dimming curve, [linear / logarithmic /
exponential / S curve].
WL SETTINGS (Figure 3):
RF channel settings, RF switch, Bluetooth
switch, Bluetooth reset.
STUDIO (Figure 4):
Set the studio mode and non-studio mode.
Studio mode: power off and turn the light
back on, restore the memory brightness
value before the power off.
Non-Studio mode: turn on the light again
after power off, restore the default brightness
value of factory settings.
FREQUENCY SETTINGS (Figure 5):
Set the dimming frequency.
FAN SETTINGS (Figure 6):
Set the cooling fan mode.
To Next Page
Loading...
