REMOTE CONTROL
23
Interface Configuration
USB Remote Interface – Optional (APS-7050 and APS-7100
only)
1.1/2.0 (full speed/auto speed)
CDC (communications device
class)
The RS-232/USB interface card (APS-002) must first
be installed before the USB interface can be used for
remote control. Please see the user manual for
installation details.
1. Connect the Type A-Type B USB
cable from the PC to the rear panel
USB B port.
2. Press the Menu key. The Menu
setting will appear on the display.
3. Use the scroll wheel to go to item 6, Rear USB
and press Enter.
4. Go to the Speed setting and set the USB speed.
5. If the connection is successful Connection Status
will change from Offline to Online.
To Next Page
Loading...
Need help?
General
