Need help?Do you have a question about the GW Instek APS-7000 Series and is the answer not in the manual?
General| Brand | GW Instek |
|---|---|
| Model | APS-7000 Series |
| Category | AC Power Distribution |
| Language | English |
Explains safety symbols used in the manual and on the instrument.
Provides general guidelines for safe operation and handling of the APS-7000.
Details AC input voltage range, frequency, and grounding requirements.
Instructions for cleaning the instrument safely.
Specifies the recommended environmental conditions for operating the instrument.
Specifies the recommended environmental conditions for storing the instrument.
Guidance on proper disposal of the instrument.
Safety instructions for using the power cord in the UK.
Provides a general overview of the APS-7000 series, including lineup and features.
Lists the key performance and interface features of the APS-7000 series.
Details the physical appearance of the APS-7000, including front and rear panels.
Lists the standard and optional communication interfaces available for the APS-7000.
Lists standard and optional accessories supplied with or available for the APS-7000.
Covers initial setup procedures, including installation and connection.
Explains fundamental operations like setting voltage, frequency, and current.
Details advanced functions such as Surge/Dip and Ramp Control.
Covers other settings like T Ipeak, Buzzer, and SCPI emulation.
Explains how to use the trigger function for output control and synchronization.
Covers saving, loading, and managing preset configurations.
Details how to create and use custom arbitrary waveforms.
Explains Simulate, Sequence, and Program modes for testing.
Details the J1 connector's functions for triggering and status monitoring.
Explains the signal output port for remotely monitoring PASS, FAIL, and Processing conditions.
Describes the SYNC output signal, which indicates when the output is turned on.
Introduces configuring various remote control interfaces like USB, RS-232, and GPIB.
Instructions for setting up the USB interface for remote control on specific models.
Details setting up the RS-232 serial interface for remote control.
Instructions for setting up the optional GPIB interface card for remote control.
Details how to set up the Ethernet connection for remote control and monitoring.
Instructions for upgrading the APS-7000 firmware using a USB flash drive.
Lists the factory default configuration settings for continuous, simulation, and sequence modes.
Detailed technical specifications for the APS-7000 series, including AC input/output and performance.
Provides physical dimensions for the APS-7050 model.
States compliance with EMC and Low Voltage directives for specific models.
To Next Page
