GW Instek APS-7000 Series User Manual

APS-7000 Series User Manual
112
Test Mode Function
There are three test modes.
 Simulate Mode: voltage/frequency fluctuations.
The Simulate function is a quick and easy way to simulate
fluctuations in voltage, frequency, phase and other anomalies in
mains supply power.
 Sequence Mode: creates test sequences.
The Sequence function creates arbitrary AC waveforms based on
user defined parameters.
 Program Mode: Runs a group of test sequences.
The Program function runs different memory steps sequentially.
Each step of a program is a preset memory configuration (M01 ~
M50). The Program function can also perform pass/fail testing.
 Simulate Mode Overview → from page 114
 Simulate Settings → from page 118
 Save Simulation to Local Memory→ from page 121
 Recall Simulation from Local Memory→ from page 121
 Manage Simulation Settings → from page 122
 Run Simulation → from page 124
 Sequence Mode Overview → from page 126
 Sequence Settings → from page 130
 Save Sequence to Local Memory → from page 134
 Recall Sequence from Local Memory → from page 134
 Manage Sequence Settings → from page 135
 Run Sequence → from page 137

GW Instek APS-7000 Series Specifications

General

Brand	GW Instek
Model	APS-7000 Series
Category	AC Power Distribution
Language	English