GW Instek APS-7100 - GPIB Function Check

REMOTE CONTROL
31
Function Active
ON, OFF
6. Set the GPIB address.
GPIB Address
0 ~ 30
GPIB port configuration
Exit
7. Press Exit[F4] to exit from the serial
port settings.
GPIB constraints
 Maximum 15 devices altogether, 20m cable
length, 2m between each device
 Unique address assigned to each device
 At least 2/3 of the devices turned On
 No loop or parallel connection
GPIB Function Check
Functionality
check
Please use the National Instruments Measurement
& Automation Controller software to confirm
GPIB/LAN functionality.
See the National Instrument website,
http://www.ni.com for details.
Operation
1. Start the NI Measurement and
Automation Explorer (MAX)
program. Using Windows, press: